Maretron FFM100 Instrukcja Użytkownika Pobierz pdf (Strona 19)

Revision 1.3 Page 15

3.4.8 Configuring Channel #0 Temperature Source

Program this parameter to match the desired instance number of the temperature reading for

this channel. You can program this parameter to any value between 0 and 252. The default

value for this parameter is 129 (User Defined).

3.4.9 Configuring Channel #0 Temperature Label

Program this parameter with a text string which identifies the particular temperature parameter

being monitored by this channel. Maretron display products will display this label text when

you are selecting data to display.

3.5 Configuring Channel #1

3.5.1 Enabling/Disabling Channel #1

NOTE: This parameter is available only when the Operating Mode of the FFM100 is set to

“Two Independent Flow Rates”.

By default, the channel is enabled and will measure the flow rate and transmit it over the

NMEA 2000 network. If this parameter is programmed to “Disable”, the channel will be

completely disabled and will not measure flow rate nor transmit it over the NMEA 2000

network.

3.5.2 Configuring Channel #1 Engine Instance

NOTE: This parameter is available only when the Operating Mode of the FFM100 is set to

“Two Independent Flow Rates”.

Program this parameter to match the desired engine instance number of the flow rate and total

fuel used for this channel. You can program this parameter to any value between 0 and 252.

3.5.3 Configuring Channel #1 Engine Label

NOTE: This parameter is available only when the Operating Mode of the FFM100 is set to

“Two Independent Flow Rates”.

Program this parameter with a text string which identifies the particular parameter being

monitored by this channel. Maretron display products will display this label text when you are

selecting data to display.

3.5.4 Configuring Channel #1 K-factor

Program this parameter to match the K-factor that appears on the flow sensor connected to

this channel.

3.5.5 Configuring Channel #1 Temperature Coefficient

NOTE: This parameter is available only when the Operating Mode of the FFM100 is set to

“Differential Mode”.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Brak uwag

Maretron FFM100 Instrukcja Użytkownika Strona 19